![]() I hope that helps all you shorter barreled 300blk users who are getting frustrated trying to find a 208 load that works with your short barrel. Well, at least I have confirmation that my load is close to good. i got my new 2016 hornady catalog last week in the mail and there. I've taken a half dozen woodchucks with it out to a touch over 100 yards. My goto has always been the 208 AMAX in a folding 10' suppressed carbine. ![]() It's incredibly quiet with the factory Hornady 190gr sub-x. This was a very helpful thread and I began researching the copper expanding like Outlaw and Cavity Backed Bullets. A bolt 300 blackout suppressed with subsonic would be much more quite. They had 11.0 grains, and overall length of 2.120"Īs his final load. The largest independent 300 Blackout reloading database. The suppressed blackout AR's still have a loud sound from the action cycling. I did enough times to start flinching (Crap), so I've put the gun away until I can mount a buttstock, or shoot it from someone's registered SBR lower, or MG lower or something. I didn't really test for accuracy, as I found out if you are using an AR15 pistol with a scope and without a buttstock and you get a scope to your face and the charging handle bops you in the nose. I live in NC where's its pretty hot and not overly high above sea level. My low was 1047fps, and my high was 1073fps. Proudly made in the USA Direct impingement, gas piston, suppressed, unsuppressed, inertia, bolt, pump, supersonic, subsonic, rifle, mid-length, carbine or. I used CCI primers, and Federal (205) and didn't notice a difference. Lake city formed brass (to 1.358" (I think)) (it fits perfectly in my Wilson case gauge and drops out effortlessly).Ģ08grn Hornady A-Max (and also the 208 Hornady MATCH) If it doesn't, I'll open the gas port in very small increments until it cycles and locks on and empty chamber.įound that the load that worked best for me was: Limited use probably only shot 150 rounds, so far 99 reliable and exceptionally accurate at this OAL in AR-15. ![]() I'm going to wait until my SBR paperwork (so I can add a stock), and my form 1 (suppressor) and then see if it locks back with the suppressor (which I will have on permanently). My gun cycles every time, but does not lock back on an empty Mag. SO, I did my own testing, and in MY gun 11.3" Wilson combat barrel, pistol length gas port opened slightly, and carbine buffer/spring, and M16 nickle boron BCG no lube. Ok, after tons of searching (badly I must add), I couldn't find any load data for a short barreled 208 Hornady A-Max A1680 load for a long time. Hornady BLACK 300 AAC Blackout 208gr A-Max Subsonic ammunition features versatile loads optimized for excellent performance from America’s favorite guns. This is for a 11.3" pistol barrel, but I hope it helps get you in the ballpark.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |